Quality Test
TENSILE TEST :
This is the destructive test carried out to obtain the mechanical test value of finished products.
FLARING & FLANGE TEST :
Flaring test is carried out to check ductility of the material & Flange Test is carried out to check the material under deformation.
REVERSE BENDING TEST :
Reverse Bend Test is done to test the welding strength of welding Tubes / Pipes.
HARDNESS TESTING :
Hardness Tester is used for measuring hardness values of Tubes & Pipes.
FLATTENING TEST :
Flattening Test is carried out to check the material under compression.
VISUAL & DIMENSION INSPECTION :
Inspection is carried out to detect any Dents, Surface Defect or Scratch on the surface of Tube. The Dimensional Inspection is carried out with calibrated measuring instruments for product dimensions are within tolerance requirements.
Destructive Test:
-
Chemical Analysis
-
Bend Test
-
Drift Expansion Test
-
Hardness Test
-
Flaring & Flattening Test
-
Tensile Test
-
Impact Test
Non-Destructive Test:
-
Hydrostatic test
-
Dye Penetration Test
-
Ultrasonic Test
-
Visual and Dimensional Test
-
Eddy Current Test
